integrale8v
Members-
Posts
98 -
Joined
-
Last visited
-
Days Won
3
integrale8v last won the day on December 11 2017
integrale8v had the most liked content!
About integrale8v
- Birthday 01/17/1979
Recent Profile Visitors
9,285 profile views
integrale8v's Achievements
-
BhdrAltn reacted to a post in a topic: Map for Bmw M30B34
-
Yes just hook it up to an Aux, set it to PWM and adjust the duty. (use injector duty cycle as axis)
-
Here is a base file with some canbus info from a E87, I am pretty sure it is the same as E90. can bra2.pcl
-
integrale8v reacted to a post in a topic: Usb to CAN (tuning cable) pinout
-
-
integrale8v started following CANBUS OIL Temp from AN8 and 12v PWM Output
-
integrale8v reacted to a post in a topic: 12v PWM Output
-
integrale8v reacted to a post in a topic: Link G3 + Toucan
-
G3 Linkplus G3 Linkplus
-
Could you send the hardware mod for the g3 plus to me also please?
-
integrale8v reacted to a post in a topic: CANBUS OIL Temp from AN8
-
integrale8v reacted to a post in a topic: RPM limit not working
-
Was doing some testing and raised the rpm limit a bit. But then it stopped working. Revved the car far past the limit. I see the injector duty on the logs show over 100% so I wonder if this fault is still in the firmware? Here are some logs and the map from the engine. (BMW s54 with compressor). https://www.jottacloud.com/s/0229a218adc332e4a7eabb1ab91ce282762 Eivind
-
M50b25tu is on/off vanos. M52b25tu is variable vanos (and ethrottle)
-
You will get the unlock code from the distributor that sold the ECU new.
-
integrale8v reacted to a post in a topic: Logging setup for ECU logging
-
Is it possible to get access to inj 7 and inj8 on the plug and play ecu?
-
What year is the engine? If it is facelift engine with 60-2 wheel you only need to change tps and install Iat sensor and ignition module. If it is preface E30 Then you must also install the 60-2 wheel and sensor from facelift.
-
Maybe this new AEM 22 channel could be a solution: http://aemelectronics.com/files/instructions/30-2212-22-Channel-CAN-Sensor-Module-Instructions.pdf cost $350usd.
-
integrale8v reacted to a post in a topic: 'Save All' logs
-
I modified the trigger, so it had 6 teeth on the crank and cam sensor. Works okay, but not perfect when starting.