Sorenjensen

Many thank for your help.

Is a plugin, i have

Thanks for the help. The pins on the ecu , I was looking for

Hi. I need an external map sensor on my Nissan skyline, it has a link 4g ECU, some that can tell me where to install the three wires. Regardes Søren

Ok thanks for the reply regards soren

Hi. I have a link 4 g ecu in my nissan skyline r34 gtr, but in the ecu is only a 2.5 bar map sensor, with a maximum of 1.5 bar boost, how can i install another map sensoe, to get more boost on. Regards Søren

I've figured it out.Â

Okay, Haw many measurements should i do, and howi write it into the pc

Hello again. how do I calibrated my aem air / fuel wideband to link 4g. at my watch shows about 14.7 to 15.2 at idle and on the PC shows the 8.7 idle, I will run quick tune program. because it gets too much fuel, the car is nissan skyline r34 gtr. Regards

ok thanks.

Hello I have set your air / fuel watch over my ecu box, red wire pin 49 black wire pin 50 white wire pin 29, and will then run quick tune, but it gets no signal, what have I forgotten to do, or I mounted the white wire wrong. euc is link 4g plug in for nissan skyline r34 gtr. Regards søren denmark.

Hello. ok I will try when coming home from work. Regards søren Â

hello. I adjusted it up and down the table, but when there is boost pressure is the air / fuel goes into the red zone, so that they may find out when they maper its. Regardes Søren

hello. I thank you very much for your help, it has been a great help , I will transfer the gasoline table tomorrow morning, and write how it goes.  Regards søren

Where can I find the main fuel table and adjust the table