Jump to content

1jz non-VVTi base map help


OllySilcock

Recommended Posts

Hi, we've recently installed a Link G4+ Fury on our S13/1jz swap. 

We'd used a 2jz basemap from online to fire up the ECU and test the coilpacks and injectors were all firing (in test mode). All worked ok. 

However, when we tried cranking the engine to start - injectors and coils won't fire. We suspect it was crank angle sensor trigger wheel settings, and tried a couple of settings found online but made no difference. Engine turned, just no spark or fuel. 

Does anyone have a basemap for a 1jz non-VVTi that we could try to just get the engine running before we take it to a tuner for mapping? Want to ensure no fuel/oil leaks or other issues first before going to Dyno. 

Engine spec;

1jz Non-VVTi

650cc Injectors

VAG coilpacks

Holset HX35 turbo

Obviously running Link MAP sensor etc. 

Thanks in advance. This would help us confirm whether we've got a crank sensor issue or if it's something more basic in the map. 

Link to comment
Share on other sites

Attached is a file from a Fury with your map loaded. I have turned off gear cut as this was on in our base map by mistake.

Suspect it could be ECU hold power causing the lack of triggers. You need to check that Di 2 is seeing an ignition switch signal.

If not using ECU hold then make sure you turn off Inj drive 8 so that it is not set as ECU Hold power.

katie gearcutoff.pclr

Edited by Simon
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...