mk2mattw Posted June 18, 2017 Report Share Posted June 18, 2017 Hi! Really could do with some help please! This car is my wedding car and if I cant get it sorted ready for the dyno on Friday I'm going to have no car for my big day! Long story short this is my first experience with a standalone and by no means an expert....clearly by this post! I have checked all the pinouts and have the car running (3.0 v6 1MZ FE in my mr2). I have got the car running and the afr to within acceptable limits, however its sitting at around 2500 rpm ,whenever I have tried to bring the idle down it hoofs the fuel through (scary 8afr) and then kills itself. The dyno is booked for 9am on Friday and I will literally have a day and a half before to try and sort this issue to get the most out of my mapping.I have cleaned the IACV and checked it motors across applying power to the open and closed side so I am confident that is working fine.I have attached the last map I saved on my laptop before I had to go away with workReally in a world of poo with this car and any help that could be given would be massively appreciated! 20170615_running well.pcl Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 19, 2017 Report Share Posted June 19, 2017 Set your ISC Mode to open loop for now. Try much smaller numbers in the base position table. Try something like halving the numbers it presently has. Quote Link to comment Share on other sites More sharing options...
mk2mattw Posted June 19, 2017 Author Report Share Posted June 19, 2017 Thanks for the reply Adam very much appreciated! Will give that a try and see where that goes Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.