ScoobydooJ Posted August 10, 2017 Report Share Posted August 10, 2017 Hi,I have a 2006 Sti with a G4 Plugin ecu installed. I have recently purchased a new wideband gauge and would like to wire the 5v output directly into the ecu. Looking at the pinout diagram, D25 (AnVolt7) is classed as wideband in my ecu. Same goes for AnVolt11. However, when I got the pinout diagram and actually looked for these wires, there is no physical wire on the car harness going into the ecu. I looked through the channels in the link software and I also have ANVolt 8 which is a spare channel. Could I therefore just splice into the wire, C23 that runs into the ecu and then assign it a calibration table? C23 does have a physical wire in the stock factory harness. Thanks in advance. John. Quote Link to comment Share on other sites More sharing options...
Simon Posted August 10, 2017 Report Share Posted August 10, 2017 Hi JohnWhat you will have is the later 06-07 ECU which has a different pinout to the 04-06You will find AN Volt 7 s on pin B4 (factory O2 signal) Quote Link to comment Share on other sites More sharing options...
ScoobydooJ Posted August 10, 2017 Author Report Share Posted August 10, 2017 Hi Simon, That excellent, thanks for getting back to me so quickly. Ill wire the the 5v out from the gauge into B4 then and make sure that the calibration matches the innovate voltage scale. Best regards,John. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.