1 pointWould be nice to be able to see at a glance if edits were additions or subtractions since last marker reset. Say on fuel table you add to a cell than the cell turns blue and if you subtracted the cell turns red.
1 pointThe continental Ethanol Content Sensors will read significant lower when low flow goes through the sensor. This means during a WOT run the ethanol content will read significantly lower at high load and rpm than at idle, because the flow in the return line is low. I attached a Log to show the problem. With more boost, I see values 20% lower at WOT than at idle. This is a well-known problem and other ECU manufacturers have an Ethanol Clamp function for a good while. The Ethanol content does with activated clamp function only update when the Injector Duty Cycle is below a certain level. Once the INJ Duty Cycle is higher than the threshold the ECU takes the last value read below the threshold and update Ethanol content only when InjDC goes below the threshold. So a quite simple function, but with a big need! Please implement it asap. Thank you.
1 pointI use a window tablet for a dash on my car and it would be nice to have some soft touch on off buttons and maybe even momentary button option to add to the screen. I control fans with the ecu and turn the water pump on with the ecu if I had a quick soft touch button I could turn things on and off with that would be very nice. It would also be nice even with a laptop we could have a diagnostic page with momentary buttons so you could quick test and make sure boost solenoid clicks of fuel pump runs and so on. Then maybe down the road something could be done with soft touch on real dash. This would clean up need for extra switches and wires a guy could even have a nitrous purge button or line lock ran with the tablet. Oops I see this was already posted.