Jump to content


Popular Content

Showing content with the highest reputation on 02/12/2018 in all areas

  1. 1 point

    coil on plug conversion

    Sorry I missed your earlier post. You can set the dwell table to have whatever you want on the axes. If the V7 base map has the setup you want to run then just open that map, right click on the dwell table, select import/export>export to clipboard. Then open your map, go to dwell table, right click, select import/export>import from clipboard. Store before shutting down.
  2. 1 point

    AEM EPM trigger G4+ PNP Coil on plug

    Your screen shot above on the Feb 1 post shows you have trig 1 set to reluctor, the AEM EPM is hall as far as I know. So set both trig 1 and 2 to optical/hall, turn on the pullup resistor. Make sure trig 2 sync mode is set to cam pulse 1X. If you still get no RPM then post a triggerscope.