Zerohour

sooo i tried to wire it and still no luck. Ran a spark test and nothing. so im going to try tommmrow again see if maybe im missing somthing

Shweet I'll try first thing in the morning and give you guys feed back this forum is awesome forsure. Appreciate it guys

Only thing is my expansion harness is ign 5,6,7,8 were my coils are hooked up on as in the pic. Do I still use 1,2,3,4 or keep it at 5,6,7,8. And wiring is set up correctly check with volt meter again just now. I'm going to check the spark edge tommorow since had to go to work lol.

I've taken cyc 2,3,4 off. Changed main spark to direct spark And turned igntion 5,6,7,8 on. Since I have a expansion harness for it The ignition test still no spark. Turned it on one by one still nothing. I'm geting power 12v and the trigger gets 8dc volt at standby but when I crank goes down to 4dc volts. Ive change dwell even to different setting from 2 or 3 different points what I've gotten online and still nothing yet

hey everyone i built a 5sgte motor thats on gen3 head and electronics. This is the first start up but i change my distributor to 1zz coil on plug and pnp harness. It is geting power to coils and the trigger 1 and 2 both say yes when cranking. but still no spark. i set dwell to these setting from a friend who sent me a base map anyone have any ideas?