RichardT

Followed the above, unfortunately when i go to calibrate the map sensor i get a... command failed: current map +/- 5kpa of baro reading. Just checking in case i have done something wrong, i have wired up the sensor via the MAF sensor wiring (have been told that it is possible) and would i still use An volt 5 for this.

Hey all, Installing a link 3 bar map sensor onto my sr20det running a link G4, but have no option for a link 3 bar sensor in sensor type. Any ideas, Cheers.

I have loaded the s14-s15 base map and still no luck. Should the pump start with key on or am i needing to change a setting?

Thanks for that, will try later today and let you know how it went.

64 pin.

Hi, Just purchased a second hand link g4 for an S13 running a sr20det from a S14 FL, i am having trouble with getting the fuel pump to operate! On the factory ecu everything operates correctly so it is a known good system. I have tried working my way through the pclink connected to the ecu with no success. (most likely doing something wrong) There is three fault codes, unsure if they are related. 1- ecu fault code 23 2- ecu fault code 11 3- ecu fault code 46 any help would be much appreciated. i have uploaded a photo of the ecu settings if its any help.