deepfriedbutter

I have installed an IAT sensor I purchased off a vendor for ST205 IAT in the manifold. It is on AN Temp 3. The only information provided by the vendor is: NTC type sensing element (Negative Temperature Coefficient means that resistance falls when temperature rises)appr 2252 Ohm at 25C (same or very close to the sensors used by automotive manufacturerssuch as BoschGMVAG). 2252 table (and aref=256) is a good starting point. Using CAL Table 1, I have tried inputing resistance and temperature values from different sensors without any luck -- the readings are way off and none of the included calibration files match or are event close to ECT at dead cold. The closest table I could find is below the graph here (link). The Std Bosch NTC looks close but still off by quite a bit. The vendor did not provide any part numbers, but after scouring the internet this is the sensor in question: https://www.emiauto.eu/en/home/1037-genuine-bmw-temperature-sensor-air-11613449116.html

are are having the same issue

Any updates on enabling datastream for black storm?

Any updates on black storm support?

I need this! Please include support for the Black Storm!

Is there a timeline for the black storm?