[Hard start]

Sweet, thank you I'll try that. 

[Hard start]

Two trigger scope captures & one log attempting to start with it set as to reluctor.

B Knight Trigger 2.llgx B Knight Trigger 3.llgx Trigger as reluctor NO GO Log 2020-05-29 6;20;42 pm.llgx

[Hard start]

Car is not here now. I tried to save the trigger patterns in the software but it hasn't saved.

Played with arming thresholds for trigger 2, anywhere from 0.5 up to 2v under crank, no change. It sees trigger 2 when logging it everytime in the logging when switched to reluctor, just wont go?

From memory under crank the peak was approx 1.5-1.8v for trigger 2. 

Change back to optical/hall & it goes, intermittently? Surely it should go at all with it set to Hall/Optical since it is in fact a reluctor sensor?

Car ran fine on stock ECU, no hard start, no miss-fires so I believe that you can rule out a cam timing issue.

When he drops it back on Tuesday I'll have to capture the trigger again. Do you just want a screen shot or is there another way to save it?

.

[Hard start]

It will not start if trigger 2 is set to Reluctor as it should be. It will only start if trigger 2 is set as Optical/hall. It is still very intermittent to start even then, but when it wont start it does not see a trigger 2, cycle key of & on a few times & it will then get a trigger 2/sync & it starts?

Pattern is good in trigger scope.