Jump to content

Btune

Members
  • Posts

    17
  • Joined

  • Last visited

Btune's Achievements

  1. https://www.loopybunny.co.uk/CarPC/k_can.html
  2. I will be getting a sniffer and check whats going on over there. Hey Vaughan, that would be of great help.
  3. Thanks for the response Adam. No success yet. Any difference if its LS First?
  4. Hey Guys im having some issues getting the AC Request from a BMW E90. I got some info from the interwebs and so far this is what ive got. CANID in dec 726 Any help would be appreciated.
  5. Hey Adam, battery on the GTR comes standard in the trunk and it grounds behind the rear seats. I could try grounding the battery to the engine for testing. Also serviced the starter and it cranks a bit faster but when it's hot and I let it sit for a while, same issue. Will check the connector since I already had to Dremel the bolt a bit as the link didnt have the proper depth for it and couldn't fasten the connector properly.
  6. Yeah I was suspecting the starter also since it cranks a tiny bit slower when hot. I attach some logs when cold when it starts with ease. thanks for the replies! log start.llgx trigger cold.llgx
  7. I attach some new logs from the trigger logger and pc logger so you can see what the RPMs do. I cleaned up some grounds and added another ground from the block to the chassis and problem still persists only on hot starts. trigger no start.llgx TriggerScopeLog.llgx
  8. Same thing when I let it warm up. I Attach more logs. nzwiring fail3.llgx
  9. Air gap without the provided shims is about 0.45mm. Last time it started missing I removed the shim and the issue persisted. Will give it a try again. Any grounding issues could be at fault?
  10. Hello, I have a customer car (R33 GTR RB26) with NZ Wiring trigger kit. Car starts perfectly and runs fine. However after some time running if if I shut it off, It wont start back up again. Trigger starts throwing errors and it doesnt sync. However if it manages to start it will run well without any errors. The problem seems to occur only on hot starts and while cranking. I attach logs and the map. Thanks! trigger rb26 nzwiring fail2.llgx trigger rb26 nzwiring working.llgx rb26 nzwiring test.pclx
  11. Btune

    MAP Level Triggering

    Hey AdamW, The car starts OK. However I was hoping it would stall or throw trigger errors when the vacuum disconnected. Also im having a hard time controlling the fueling. If I change my master fuel value by 1 it swings from 8afr to 20afr. Will try with the settings you mention. thanks!
  12. Btune

    MAP Level Triggering

    Sorry, missed it. TriggerScopeLognew.llgx
  13. Btune

    MAP Level Triggering

    Here you go Adam. ECU Log 2021-01-4 11_53_46 am.llgx
  14. Btune

    MAP Level Triggering

    Hello guys, I've been trying to setup a similar setup and having some issues with the map sync. I attach a log of the car idling. Any suggestions for the sync tooth and map offset? It would be nice if there was a way to verify the sync from Map level when using this strategy. Thanks said log1.llgx
×
×
  • Create New...