Jump to content


  • Content Count

  • Joined

  • Last visited

  1. Hey, thanks! I followed your steps and updated those settings and was able to start the car! I can see RPM in PCLink and the car's tachometer. It sounds terrible and runs only with the throttle open to 50%. It's also smoking a lot, but that's probably from oil that leaked past the pistons and into the head when I had the motor out of the car. The alternator is squeaking, so I'm going to replace it, and then see if the oil burns away. Also, I was able to verify oil pressure only after it started, not while cranking.
  2. Hi Adam, Thanks for the reply. The RPM does not change when I'm cranking, neither in PCLink, nor on the car's tachometer. It seems that this tells you something... I'm showing "Fault code 49: An temp 3 above error high value" but I think that's just the IAT sensor. I have also tried unplugging the camshaft position sensor to disable fuel and spark. Only when I disconnect the CPS do I see the error: "Fault code 26: An volt 6 error below low value." The car's dash doesn't show any oil pressure when I crank the starter for a few seconds, nor does the PCLink software show any oil pressure. Thanks again for the help.
  3. Hello, I've just finished restoring a 1991 R32 GTR. I have some experience with Hondata, but I'm struggling to figure out the basic settings that I need in PCLink to simply get the motor started. I'd like to make sure everything is working properly before I bring it to a tuner. I've tried to start the motor with the basemap included in the software, but it doesn't work. Setup: Older G4 ECU ID2000 high-impedance injectors Fuel pressure regulator set to 40psi R35 coil packs (dwell time should not exceed 4.5? instructions attached) 92 octane gasoline I have updated the firmware and calibrated the MAP and TPS. If anybody could help with a modified basemap or making the correct settings in PCLink, I would appreciate it. If I can provide more information, let me know. Thank you very much in advance. ~Jason Nissan GTS-GTR G4 Storm Plugin.pcl Supertec Racing VR38 to RB Coil Adapter Kit Install Guide Rev.3.pdf
  • Create New...