gtr-import

Hi fellows , i have a E36 Turbo with M50B20 engine , i use a plugnplay B25 ECU , would like to adjust my timing offset to be sure what i want it's what i get , but can't found the OEM value at idle , if someone can i have the info it will be helpfull. cheers

Hello everybody , would like to upgrade from my G4+ to a G4X , i have a lot of extra future on my G4+ don't want to fill all the table and optionals futures , is it possible to transform G4+ files in G4X files ? thanks in advance.

Hello everybody, witch config i have to use on G4X for CAS ? on G4+ it's 360 opto config , but on G4X it won't start with that , i try another config ( 360 opto with distributor) and the engine start and idle is perfect after advance calibration of course.

Hi, thanks for your reply, yes i use D4 for clim input , i try also other DI input. the aircon system is full of gas , so no reason to not have digital signal from the aircon control unit , i have also try another one , but no sucess .Maybe if something wrong , (faulty sensor) , DI signal is not sent form the unit to the ECU , but i didn't found how to put climate control in diag mode on the R34 GTR. If somebody know how to do it , help will be apreciate . Thanks

Hello everybody , try to drive the AC on a R34 GTR , can't change the status trought any DI entry availlable on link G4+ i try all the config ( pull up on or off , low or high). thanks for your help.

Hello everybody, Need to fill some data on my link plug in ECU to use the modeled multi fuel mode , I use 1200cc on my R32 GTR from DW , just ask them to provide accurate data to fill the dead time table and pulse width table and they provide me the following information , don't know if I can use it , because they don't seem to be usefull on the link G4+ what do you think ? https://www.deatschwerks.com/sites/www.deatschwerks.com/files/DATA/injectordata/42M%201200cc%20Technical%20Data%20Sheet.pdf tanks for the reply

just check the sensors , they are wired right , Ov is present at the right pin and 5v also ( 4,95V) . I check at the ecu pin , I use AN volt 4 and 5 for my pressure sensors , I have approx 0,2 volts at the pin but PC link show me zero , even when the fuel pump is on , i didn't start the engine yet just left the ignition on , I prefer test all my sensor before cranck the engine.

thanks , i will check that , I hope they are not Chinese copy , they came from a Link dealer in UK.

hello guys, try to have my Link ( variohm) pressure sensors data , oil pressure and fuel pressure with the link , but when I use the sensor brand in the list ( 150PSI TI sensor ) the reading is zero . if I try another brand the data are wrong but it don't show zero , can I have some help for my sensor calibration , don't found calibration table anywhere for the Link sensor.