Nadeerawick

Hi all, I using Link Monsoon and i noticed recently, trigger err counter 2. err counter 2 is normal or there is any serious issue with the trigger. the trigger err 2 what could be the reason ? Thanks

Ok thanks a lot for quick feed back

Thanks for the Reply Adam. did you see the injector dead time whether is correct what i have mentioned ?

Hi Link family, I need your support I’m a beginner for tuning I got a link G4 monsoon and running 2003 RSX (Base) K20 (Stock Motor) and stock injectors 270cc. I was step up injector for traditional with pump gas 98. Now I want to run Modelled Mode. I got stuck in the Injector dead time and short pulse wide. I have found Injector dead time in HONADTA, but still I cannot find the short pulse wide Can you help me to find this and if there is any formula please share with me? Injector Dead Time Injector Deadtimes Batt Voltage (V) 6.07 8.09 10.69 14.06 16.08 4.72 2.38 1.3 0.84 0.66 Injector Flow @ Rated Pressure? Injector short Pulse wide? Base Fuel Pressure?

Hi adamw I have a question regarding launch control. i want to use launch control on the road So i fixed DI 1= is On/off Switch ,D1 3 = VVS My car is RSX 2002 Can you please give me good set for this Thanks

Hi guys, I need some advice; I am about to purchase plex V2 knock monitor I would like to know any commits using a knock monitor (advantage and disadvantage) and any good knock monitors rather than use Plex V2? if I use knock monitor will it show accurate? and is it limited to the permanence? Thanks Nad

Thanks a lot CJ

HI friends, Am Looking for a K20 base Map. Hope someone can help me. Thanks and regards

Hi Cj and Adamn, I've learned something today. Thanks a lot guys. good luck Cheers

Yea i will check the engine number and let you know bro. Right now am running on Traditional mode. but still couldn't find, where i can change the Injector size (310cc or 270cc) and even i cannot change battary Volt (axis

Hi Cj, Bro I know its Only below information of my car Modal 2003 Engine K20 Stock RSX base Model i have got some information from K manager software. please see screenshot below K20 RSX type S is 310cc injector but am confused right now.

Hi there, I'M running K20 injector, i think its 270cc. i want to change the injector dead timing and flow rate and about to change the battery Volt am not able to change Axis setup. could you please help me to sorted out this and please share with me injector dead timing and flow rate Thanks Guys, Cheers