Jump to content

Vidar

Members
  • Posts

    38
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Vidar's Achievements

  1. Vidar

    g4x aux output

    anyone know max amp draw on aux output og g4x? both high and low side? and is this same on g5?
  2. Vidar

    can lambda on plug in

    did find the link can lambda, it says 8amp draw on warmup, and recomended fuse is 10amp.
  3. Vidar

    can lambda on plug in

    how much amps do the can lambda draw on warmup?
  4. have a r33gts here with plug in and is installing can lambda. i se i have 12v and ground in can extension loom. is that enough for can lambda? or is it better to suply power and ground from another place?
  5. customer who didn't got mesurement on oil press, switched it with fuel press(same sensor) got wrong mesurement on fuel and wrong on oil. will be delivered back too us and shipped back too link. customer state it measure 0,0 in pressure all time.
  6. have a customer with faulty sensor. pressure reading has suddenly become wrong. anybody had failure with these sensors?
  7. had same problem with pins here. solution was too buy new pins.
  8. then shimless is way too go. if there is stock buckets, fuel cut is best thing...
  9. my suggestion too customer was shimless bucket. but has anybody had a success with a noisy(what customer want) 2step/launch controll that dont grenade valvetrain?
  10. have a customer here who realy want sandig still launch controll with pops and bang. whe have tried earlier, resulting in valve lifters/shim came off. no its standing on fuel cut, with -5% retard ignition. but customer thinks its a little boring. so any god suggestion on lunch controll/two step setting that will not destroy walve lifters and cam. eninge is 2jz, built bottom end, bc 264 cams, non vvti, garret gtx3584rs gen 2 turbo, link 1000cc injectors, link g4 supralink. dyno is 620whp on 1.5bar in boost.. boost is 1,5bar at 4000rpm and stable to 8000rpm. no adjustment on cam gears. valve lifters are with shim on top btw.
  11. Vidar

    evo 9 g4x base timing

    but stock timing mark on is by the front of engine?
  12. stupid question, but installed evolink9 g4x on a evo9. its a complete build engine, cams, pistons, rods and so on. cant find timing marks on engine, have anybody a good easy way to check base timing? or is stock setting so close its no point? its adjustable cam gears. dont know if it uses cam og crank as base for tdc.
  13. have a fault here, no spark/ign with vipec ecu connected. ecu is updated firmware, tried diffrent map(also stock) no spark. have rpm while "crankink" no trigger errors. this happend today, we was going too tune it today. it have been running several times before. if we plug in stock ecu it fires straight up. does anybode had this problem before?
  14. Vidar

    Polaris rmk 2011

    Thank you very much:-)
  15. Vidar

    Polaris rmk 2011

    Have you spoken to Simon?
×
×
  • Create New...