JZX100

I connected inj8 (orange wire) to the old tachometer wire and set it in the program (See all the photos attached) but still can not function in my panel and also no response in AC button! Any wrong in my work? Please help

Stupid me the pin being pulled out fixed all good now sorry

Another issue about ITA same Bosch ITA 0280130017 is no more working in X same setting is fine in G4+ Successful connected! Thx

After load the can stream file, it can not show on the program & show check ECU firmware! Is this attached file for G4X?

Yes In runtime valve nothing happen on all DI when press AC DI6 should show active or inactive but nothing happened. Not even all other DI thus I’m wonder if it would be possible the signal is on the other Pin 20’ not 19.....

Dear Vaughan, Can you give me the stream file for AEM X-series UEGO Gauge Receive to setup the CAN? My ECU is G4X JZX100 plugin! Many thanks! Besides, when I set up the Air Conditioner at the G4X program, some problem occurs, the A/C control panel can not run with the ECU at the same time. Any advice?

Thank you very much Buddy!

Dear Adamw, No base map for JZX100 was loaded inside the G4+ & G4X program. Only found the base map for Altezza, celica and supra etc. Waiting for your good news. Many thx.

Hi buddies, I bought a G4X plug-in for my JZX100, where can download the base map for JZX 1JZ vvti turbo engine? I had not any information for that car. Thank you very much! BR, JZX lovers