Jump to content

IGMAB

Members
  • Posts

    7
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

IGMAB's Achievements

  1. IGMAB

    Dual Keypads

    Just read what AdamW wrote about using a mathblock to control leds with different parameters. Will try that tomorrow.
  2. IGMAB

    Dual Keypads

    Started from scratch this morning, and now everything seems to work as supposed. I'm using CAN aux from the ecu to control 3 outputs in one of the pdm's (fuelpump, coolingfan and waterpump ). This works fine. But I'm also using one of the keypads to manually control theese outputs (for example when engine isn't running). Works also fine. But... Should be really nice if the led's in the keypad could be activated even if the outputs being controlled by the ecu. Is this somehow possible to achieve?
  3. IGMAB

    Dual Keypads

    Thanks for yor reply Vaughan! The strange thing is that button 1-4 on the keypad4 does exact the same thing as button 1-4 on the keypad8 (seems like they are mirrored). Another thing is that when scanning for can-device in pc-link, it only find 1 keypad (keypad4). But if I disconnect keypad4, pc-link will recognize keypad8. I will start over to be sure that I've not mixed things up.
  4. IGMAB

    Dual Keypads

    Setting up a system with following: G4XFury - 2x Razor PDM - Keypad8 - Keypad4 Keypad4 buttons does exact the same thing as the first 4 buttons in keypad8, so I guess that something is wrong in the setup. Keypad8 is set to CanID 405 (384+nodeID 21) and Keypad4 is nodeID changed to 22 (via PC-link). Keypad4 now has CanID 406. Is this correct? Should the Keypads setup be in just 1 of the PDM's, or should it be in the ECU? Keypad buttons should be used to control outputs in both PDM's, and also to change the launch-rpm up/down. Best Regards Martin
  5. IGMAB

    MXG custom CAN stream

    Hi Adam! I've seen the launch status in the default ecu stream, but I see no change in status (probably because I run the system on the bench, without engine). Thanks for your help
  6. Working with a G4x Fury that talks to a MXG 1.2 Strada (can). All works fine but I would like to have a couple of things extra in the dash. Have a 12-step rotaryswitch for 12 different launch-rpm's connected to An4. Also have a launch-switch connected to dig1. I'm only running it on the bench so far (engine should be ready, and put in the dyno during next week). Plan is that when pushing the launchbutton, the dash should change to page3, wich would only show LAUNCH RPM, actual rpm, tps, ect and eop. When releasing launchbutton dash should go back to normal. This is no problem to achieve, if I could read both dig1(launch) and Launchrpm in the canstream. I understood that it's possible to add/remove variables in the canstream, but dont know how to do it. Attached both files. Regards Martin 11-22 3L J Verkuringen.pclx MXG 1.x Strada Verkuringen.zconfig
  7. Hi guys! Trying to start a VQ35DE engine for the first time (G4+ Fury). Trigger 1 goes to crank. Trigger 2 goes to caM RH. When looking at triggerscope, I got a fine signal from trigger2. Trigger 1 doesnt move at all (~13V all the time). Have changed the cranksensor without any improvement. Any suggestions? Regards Martin (Sweden)
×
×
  • Create New...