Samueljon

Comes up with 2 error codes and this when you click on them

Hi, going to set this all up this weekend, just to double check, leave the Ecu set as ADM and set the timing up as normal ignoring the warning saying it’s in the wrong rotation cheers sam

What would be the best way to set the base timing without the car running? the car was running before the new set up (nistune and the standard cas)

I haven’t properly set the base timing yet, I installed the sensor in the week, I shall try and get on setting the base to timing this week. i assume that’s a timing light jobbie

sorry adam, the laptop has a hard time keeping up with the clicking! attached is the new scope Sam S14 trigger scope.llgx

morning/afternoon/evening ive attatched the current base map with the trig scope while the ecu is set to ADM thanks sam Sam S14 trigger scope.llgx Sam S14.pclx

Hi I seem to be missing the trig1 signal and rpm when the Ecu has the switches flicked to the Jdm/nz position but when on ADM I get both trigs and rpm but the engine is rotating in reverse apparently. Its an sr20det running a taarks hall sensor set up thanks for any help

i have a dash2 with a CAN adapter (I had the pro software open to just to check I wasn’t being stupid) it seems to have every other Ecu on their drop down menu

Unfortunately I think that’s for the dash2pro version and not the simpler dash2, it doesn’t seem to want to load onto my dash2, I get a warning come up telling me it’s a dash2pro file and it can’t continue sam

Trying to link my Race Technology dash2 with the g4x but it doesn’t seem to have any files in the can section of the link download, searched about but couldn’t seem to find an answer. Thanks in advance

Yup that’s what I ended up with, it’s just upside down wrong way round compared to the g4+ thanks for your help! And fast responses Sam

It’s for an air temp sensor, I’ve copied the link from which it was purchased https://shopbhp.com/products/copy-of-cosworth-yb-air-temperature-sensor-ats04?_pos=1&_sid=27ba36ec3&_ss=r

Yeah they’re exactly the same sensor wired the same. Thanks for the help

Perfect thank you for the quick response, this is what I’ve currently got to work with from what my friend has sent over. So it’s just a case of switching the table?

Hi, recently installed my link g4x and I’m trying to make a cal table for an air temp sensor. My friend has a link g4+ and has sent me his cal table for the same sensor, I’m just wondering if these can be copied across between the 2 ecu’s thanks sam