Colinmcraika

Im going to be running a link thunder with a hardwire pdm and a blink marine push button control panel. Question I have is can I use the CAN signal from the panel to activate different boost maps?

Hi adam yep it is reading it over the can and does it whilst vehicle is stationary, il have a look though the dash and see what can be changed in there

Hi guys, Im running a link fury on a 13b using a microtech 7" display. Ive been using the dash last 2 years displaying the basics temp, press, afr, a couple weeks ago i set up gear detection on my h pattern gear box using magnets and prox switches on slide rails for shift cut. works fine on the ecu, when i send over can to dash gears 234 are correct but netural displays 1st and 5th is 0. 1st gear displays 5th, has any1 delt with this problem before?

Awsome thanks for the reply, will have a go at it in a couple weeks

Hi team Just a quick question regarding my new sequential gear box setup. Im running link g4+ fury i have an albins st6 and the hollinger shift cut knob, so will be setting up closed loop shift cut etc and running the gear display on my dash, so anyway as this box has no reverse switch can i configure a low side output to operate a relay in reverse to run my reverse lights?