Jump to content

teme76

Members
  • Posts

    6
  • Joined

  • Last visited

teme76's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Stepper motor position is little bit confusing to me... VTS says "Base positition: Step count from full open". So if Fan will start it will ADD "Engine fan step" parameter to current position?
  2. I'm using that 1N4007 and I measured it and it's ok. I hope that you can found some mistake from my parameters... Corvette-89.zip
  3. I get this message... "The extension pcl is not allowed."
  4. I checked again wiring and everything seems like on page 26 (ecu hold power wiring). Ignition is on Digital 7(B30) and is working ok. Ecu hold power is on Aux 10(B26). When ignition is off none of Aux connectors have voltage. More ideas? How to upload that PCL file to here?
  5. Finally I finished my wiring. Few problems found... Ecu hold power relay stays on when I switch off ignition. Status stays active. Ideas what could cause that? Fuel pump works when I force it on, but won't prime (time = 2sec.) when I switch on ignition. Something to do with my first problem maybe? Teme
×
×
  • Create New...