Jump to content

spawn_CA18

Members
  • Posts

    4
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

spawn_CA18's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Done !... http://youtu.be/7dzbc7Jx2XM
  2. i found TPS 5 V signal on ecu connector . if i use it does my pot works as voltage divider or works properly? either i couldn't find any other 5V on ecu connector
  3. thank you simon , i prepared the pot and installed already. which pins to use in CA18 short header as +5 source and signal ground? i see there is on expansion but i dont have expansion cable.
  4. Hello , I have checked all forum but could find a solid answer. ı'm planning to do a pot controlled boost table . On the software no problem i arranged the table by An V1 (which is selected as 0-5V input and calibrated to 0-5v % 0-100 ) But i couldn't find answer which rate of ohm to use in An V1 to arrange it between 0-5 V I think it is 1k ohm but i can not be sure. thank you
×
×
  • Create New...