Joe Prostreet

For speedo out, I can set AUX17 or AUX18 to speedo out but no have out put pulse form that AUX.I try to set as Test (PWM) and use oscilloscope to check they had pulse come out but when changed function to Speedo Out, run the car - had nothing, when changed to AUX6 it's work fine. For the input value, when i type such as -5, in the pop-up box warn me "Too big! Max is 0" but can change by press PGUP/PGDN.

I just found Speedo Out cannot work on AUX 17,18 (Thunder ECU). I've change to AUX 6 it work normally. Another found is cannot input the number directly on some parameter such as, Overrun Fuel Cut - Ignition Retard. But the number can change by press PGUP/PGDN.

Hi Scott, thank you vary much for your help.

Hello all, Did anyone can suggest me what sensor type I've to calibrated for 1/8 BSP AIT & 1/8 BSP NTC? Can I select Std Bosch NTC with 1kOhm (Internal) Pullup Resister for both sensors? And the new Link Variohm 1000 kpa pressure sensor, Can I select 1000 kpa TI Sensor or I've to use the calibration value that printed on the sensor? Thank you very much. :-) Variohm 1000 kpa pressure sensor

I've done with modelled fuel equation on a few 13B & 20B engine. It's commom.

Thank you very much for your quick reply. :-)

Dear all, After I've updated, when I open offline file or go online the Axis parameter that I had config with Differential Fuel Pressure in injector dead time table had been missing and cant set Differential Fuel Pressure to Injector Dead time Axis anymore! Then I've to roll back to 5.5.6.2942 version. Did anyone facing like this?