-
Posts
19,848 -
Joined
-
Last visited
-
Days Won
1,266
Adamw's Achievements
Single Status Update
-
Hello Adam,
continuing to love my V88. :).
from 2013 forward my boost setup has been closed loop set up on a dyno w my tuner. last fall i decided to do some experimenting w open loop. did that for a while and decide to go back to open loop. i believe i did everything correctly but went for a drive yesterday and had absolutely no WG duty... zero. boost was off the spring yet i had the boost target at 238 kpa/20 psi.
i believe all my hardware is top notch and it must be some settings issue although i have done my best to check.
i have a log from the run and my computer says it is 3.4 M but when i attempt to load it it says the file size is too large. i will attempt to send just the log on a follow on message.
i do have a few other issues that you could perhaps help with...
neither my old laptop, HP Pavilion, or my new laptop Dell Inspiron 17, seem to work re the "F" keys. i have always wanted the snake trail but never been able to enable it... F6 and . or ,
maybe this is a question for a computer guy but there should be able to be a way to redirect the keys away from some other usage? wud love the snake trail for tuning.
another issue w both laptops is i can only load two lines of a new fuel table. if i construct a new table from mixture map the computer will disconnect if i try to load it in toto. the best i can do is 2 lines.
Thank You Adam and have a nice monday.
Howard Coleman
-
follow on log re no wastegate management w my closed loop settings. also, what is triggering the galloping at the end of the log please...
-
follow on log re no wastegate management w my closed loop settings. also, what is triggering the galloping at the end of the log please...
first message should read i decided to go back to CLOSED LOOP
-