mkiv

I am having similar issue (either run out of memory or pclink crashed ) on surface pro running windows 10 Any solution for this ? THanks. LEO

that is the thing, blitz meter reads exactly like in ecu. having said that the blitz has a setting that i can configure. however it was never reconfigured even after ecu swapped to g4+. the meter is sbc i color spec r. it is boost controller actually. as for multiplier i guess the smallest unit is 1? may be witth updated firmware i get smaller multiplier?, correct me if there is smaller than 1 multiplier available. all i can say after g4+ swapped, sweep never sweep to configured value, but v88 does it fine. just cant get my head around this. may be you can help finding a way to trouble shoot this ?

it is unexplainable then in that case ? even the sweep function was spot on in v88, but g4+ will just go past set point no matter what setting ..

totally understand that but the weird part is that if i connect v88 back in no longer have the issue.. ecu calculation problem ?

mine the same still having 100-250 rpm out issue. i have a blitz meter connected to same signal and it is showing correct rpm as shown in ecu. only stock cluster is not showing correct rpm. i didnt have this issue with v88 before swaping ecu to thunder. Simon or tech people, is there a way to see where the problem lies ? thx

Hi Muzzy, Where did you get the speed signal from ? Did you get it from PRE-ABS directly from wheel speed sensor or post ABS ? I think there are output signal from ABS to OEM ecu available but i haven't tried that yet (shown in blue area). I am also in the process of wiring this up to my Thunder, I found it easier to get the signal directly from OEM ecu loom without having to pull apart my dash provided if those signal work. So was just wondering if you may be already try signal from there? Thanks LEO

lostsoul, has your sweep past set value fixed as well ?