Jump to content

gijsje

Members
  • Posts

    11
  • Joined

  • Last visited

  • Days Won

    2

gijsje last won the day on December 26 2018

gijsje had the most liked content!

Recent Profile Visitors

688 profile views

gijsje's Achievements

Newbie

Newbie (1/14)

2

Reputation

  1. I asked realdash on Facebook and this was the answer These values are in 'ECU Specific category'. Since these values are generic and user configurable RealDash does not know which generic input is used for what purpose, thus they cannot be mapped directly to AFR etc. So thats to bad
  2. I have this working now but i do not see the wide band connected to AN Volt2 or any other sensor connected to AN Volt (oil pressure, Oil Temp, fuel pressure) Is there anything i need to change somewhere? Thanks in advance
  3. i now have upgarded from the G4 to the G4+ and was looking in wire in the wheel sensors After looking in the help file i did find that you need to wire them to DI1 to DI6 But some are already in use DI1 Power steer DI2 Start position DI3 Vehicle speed DI4 AC request So in the series 1 to 6 4 are already taken by something else. Is it also posible to wire the ones already connected to another DI input? I was also looking at the wire pinouts and i could not find DI7 and DI8 Where can i find them??? DI1 Pin 19 main harnass (Power steer) DI2 Pin 43 main harnass (Start position) DI3 Pin 53 main harnass (Vehicle speed) DI4 Pin 46 main harnass (AC request) DI5 Expansion connector 1 pin 3 DI6 Expansion connector 1 pin 4 DI7 not found DI8 not found DI9 Expansion connector 2 pin 5 DI10 Expansion connector 2 pin 6
  4. gijsje

    User CAN Setup

    sold the g4 now getting a g4+ should work much better with the obd function
  5. I am upgrading form a G4 plugin gtr to a plugin G4+gtr in the R32 GTR can you copy the old tune of the G4 to the G4+ ? Will all the setting be copied?
  6. gijsje

    User CAN Setup

    Thats realy sad then Want to communicate with aruino and or raspberry pi
  7. gijsje

    User CAN Setup

    i have now installed the VTS (V 4.10.2) and did try to make a new lcc file and edit an existing lcc file but with both i do get the same message that it was not made with the link software and then it does not load Is there a way to enable this option in the link G4 software?
  8. gijsje

    User CAN Setup

    How can i change the User CAN Setup ? All is gray and i can not change it I did try the vipec software and there you are able to change and to save but when you open it in the link software it says that it was not made with the link software
  9. gijsje

    AIM datastream

    it uses rs232 aim data stream
  10. gijsje

    AIM datastream

    I am trying to hook up a divice that can read the aim datastream but i am unable to connect the RB plug in module. On what port do i need to connect this? is is to the usb port or to the rs232 port on the board? i could not find any information about the rs232 port
  11. i had almost the same question about a gtr plugin two days ago and the forum changed
×
×
  • Create New...