gijsje
-
Posts
11 -
Joined
-
Last visited
-
Days Won
2
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by gijsje
-
-
-
i now have upgarded from the G4 to the G4+ and was looking in wire in the wheel sensors
After looking in the help file i did find that you need to wire them to DI1 to DI6
But some are already in use
DI1 Power steer
DI2 Start position
DI3 Vehicle speed
DI4 AC request
So in the series 1 to 6 4 are already taken by something else.
Is it also posible to wire the ones already connected to another DI input?
I was also looking at the wire pinouts and i could not find DI7 and DI8
Where can i find them???
DI1 Pin 19 main harnass (Power steer)
DI2 Pin 43 main harnass (Start position)
DI3 Pin 53 main harnass (Vehicle speed)
DI4 Pin 46 main harnass (AC request)
DI5 Expansion connector 1 pin 3
DI6 Expansion connector 1 pin 4
DI7 not found
DI8 not found
DI9 Expansion connector 2 pin 5
DI10 Expansion connector 2 pin 6
-
-
I am upgrading form a G4 plugin gtr to a plugin G4+gtr in the R32 GTR
can you copy the old tune of the G4 to the G4+ ?
Will all the setting be copied?
-
Thats realy sad then
Want to communicate with aruino and or raspberry pi
-
i have now installed the VTS (V 4.10.2) and did try to make a new lcc file and edit an existing lcc file but with both i do get the same message that it was not made with the link software and then it does not load
Is there a way to enable this option in the link G4 software?
-
How can i change the User CAN Setup ?
All is gray and i can not change it
I did try the vipec software and there you are able to change and to save but when you open it in the link software it says that it was not made with the link software
-
it uses rs232 aim data stream
-
I am trying to hook up a divice that can read the aim datastream but i am unable to connect the RB plug in module.
On what port do i need to connect this?
is is to the usb port or to the rs232 port on the board?
i could not find any information about the rs232 port
-
i had almost the same question about a gtr plugin two days ago and the forum changed
Introducing RealDash - A Dashboard App for Android & Windows
in G4+
Posted
I asked realdash on Facebook and this was the answer
These values are in 'ECU Specific category'.
Since these values are generic and user configurable RealDash does not know which generic input is used for what purpose, thus they cannot be mapped directly to AFR etc.
So thats to bad