lostsoul
Members-
Posts
168 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Everything posted by lostsoul
-
Hi, I seem to have a problem with "Mixture Map" ... If I put any filter/conditions in, the table come up completely blank.
-
Was wondering because on a restart after a stall ( without powering the cup down ) there are Trigger Errors.
-
-
Can someone confirm the Audi R8 Coil connector wiring ?
-
After calibrating each gear as per the help section, do you the turn "Gear Calibration" OFF again?
-
Had a play with things as per your suggestions and a few other thoughts I had. Not looking to bad now ? Using a screen shot of the 1st 30 -40 sec as the log file was a fraction too big.
-
Can someone take a look at my Cold Start ... The engine speed osculates up and down for the first 40 sec or so on a cold start. Thanks in advance. TPS Fuel Table Load DEFAULT Cold start un altered.pclr Cold start.llg
-
I am not using a kit as such ... I am using a Snow Performance Pump and Safe Injection unit. Everything is run by the ecu, so I guess I have made my own kit.
-
I have water/meth setup controlled by the ecu ( g4+) ... the ecu drives the pump via a SSR and I have it setup so that if the water/meth flow drops, tank gets below a set level or I just have it turned off, the ecu switches to a "safe" Fuel/Ignition and Boost table. When the tune is finished I can let you know how well it works or dosn't ;-)
-
Had thought about the IAT correction but thought that should off if using Modeled Fuel Equation ?
-
When restarting after the engine has reached operating temp it is very lean ( 1.3ish lambda ) for 30 - 60 sec. I have increase the post start enrichment and the post start decay time .... has improved but still about 1.1ish lambda. Is there anything else I could/should be looking at?
-
???? when I check the gear status via a log I get "0" I will try re-calibrating and let you how I get on. Cheers
-
I have gone through the Gear Calibration procedure and got the "Finished" message for each gear. However when the car is out on the road the "gear status" remains at "0". Can someone check my pclr. file to see if I have missed something? Thanks TPS Tune.pclr
-
Hey Adam, I have been going over the adjustments you made for me and have some questions. Do I have to retain DI 7 toggle switch (currently activating Slip Table 2 ) ? If not is OK to have just 1 slip Table activated by the DI 5 Traction on/off switch?
-
Perfect ... I would never have figured this out, your a legend.
-
Attached.... TPS-Tune.pclr
-
Thanks Adam, that is all pretty much chinese to me. Could you post screenshots of how this would be set up in PC Link ? Please.
-
I currently have the Traction Control setup with a switch to go from "wet" or "Dry" conditions. What I would really like is a Rotary Switch adjustment instead ... would this do the Job ? https://www.aemelectronics.com/?q=products/sensors-connectors-accessories/12-position-trim-pot