My setup has a reluctor(?) type trigger using a crank wheel with 5 teeth. The first is at TDC for #1 cylinder with the second about 5deg behind. The other three teeth are at roughly 90deg intervals. A sketch of the wheel is attached to an email I sent to the techsupport email address on the weekend. You might also be able to identify my unit configuration from the same email. I bought it from Link in ChCh in July 2005.
I hope this helps
Regards
Bruce
My crank angle sensor does not appear to allow base timing to be advanced beyond TDC. Is there some way I can do this with my Linkplus V14 rather than having to modify the reluctor bracket?
Hi,
I am trying to install an Innovate Wideband Lamda controller with a Linkplus V14 ECU. The LC-1 gives options of simulated narrow band output and linear analog output. What should I use with the V14?
Bruce