DillonG

Thanks for that Scott! Much appreciated. I did see that link earlier in my searches but couldnt find the exact answer I was looking for. For future reference this is the distributor: Â Four wire plug, green, red, white and yellow coloured wires. So the red wire goes down to the 4 tooth wheel, which will be trigger 1. Green to the single tooth wheel at the top, trigger 2. White wire splits in to 3 and goes to each sensor (they look yellow inside the distributor), so I assume this is the sensor ground? and Yellow is unused?

Just purchased a new G4+ Atom to replace the early G1 LEM I was using. Engine is a 16v small port (red top) 4AGE. Most of the wiring up to this stage has been straight forward, but I am stuck with the trigger wiring. Distributor seems to be a 4/1 tooth wheel (4 on the lower, one on the top) setup, which I cant seem find a pin out for on the internet so not sure where I should connect trigger 1 and 2 to? Anyone here have any experience with this? Using direct ignition setup (1NZFE coilpacks). Cheers, Dillon.