Jo LeForce
-
Posts
53 -
Joined
-
Last visited
Reputation Activity
-
Jo LeForce reacted to Calvin in Water/meth basic failsafe setup
For RPM limit, after you enable the GP RPM Limit table, right-click the table and select 'Axis Setup', you then select DI X (status), x being your pin number. Set the other axis to 'none'.
After that you can now set your limits,
-
Jo LeForce reacted to Adamw in High impedance injectors + resistor box
With the resistor in place the deadtimes will likely be quite wrong. It wont be noticeable when everything is relatively stable as the deadtime error will just be "baked in" to the fuel map. But if for example battery voltage changes (ie headlights of fan turns on) then the incorrect deadtimes arent going to compensate for that as well as they should. If you remove the resistor you will likely need to retune the fuel table. You wont do any damage to ecu or injector - just higher risk that all operating conditions wont be compensated for well.
-
Jo LeForce reacted to ClintBHP in Always hitting LC rev limit on the run!
Change that to :
Driven wheel speed source is set to: OFF
Non driven wheel speed source is set to: LF Wheel Speed
-
Jo LeForce reacted to ClintBHP in Always hitting LC rev limit on the run!
Under Chassis and Body what is your Speed Source set to ?
If looking here does not solve your issue please upload map and log file.
