Jump to content

Steven Oakley

Members
  • Posts

    6
  • Joined

  • Last visited

    Never

Steven Oakley's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Ok The Trigger Wires are back to front They should be: C: Green/Black (1 Degree) = Trigger 1 Black D: Green Yellow (180 Degree) = Trigger 2 Red
  2. My wiring set up: CA18DET wire colors on the left Link G4 Storm on the right C.A.S Wiring: A: Black Wire (Earth) = Trigger 1&2 Sensor Ground White x2 B: Black/White (Power) = +8v Red/White C: Green/Black (1 Degree) = Trigger 2 Red D: Green Yellow (180 Degree) = Trigger 1 Black Injector High Impedance: Injector 1: White/Black = Brown/Black White = 12v switched Injector 2: Yellow/Black = Brown Yellow = 12v Switched Injector 3: Green/Black = Brown/Red Green = 12v Switched Injector 4: Blue/Black = Brown/Orange Blue = 12v Switched T.P.S: Black (earth) = Green (sensor ground) Light Blue/Red = Yellow/Blue (An Volt 1) Light Blue/Black = Red/Blue (+5v) Engine Coolant Temp: Black/Orange = Yellow (Temp 1) Black = Green (Sensor Ground) Bosch 0 280 130 085 (Air Temp Inlet) Yellow/Brown (Temp 2) Green (sensor Ground) Coil Pack  Igniter: pack 1: Red/White = Blue (ing 1) Pack 2: Red/Yellow = Blue/Brown (ing 2) Pack 3: Red/Green = Blue/Red (ing 3) Pack 4 Red/Blue = Blue/Orange (ing 4) ECU SET UP A1: Engine Fan (hs) A2: Engine Fan A3: Tacho A4: Fuel Pump A5: Boost Solenoid AN V2: TPS AN V3: Wideband (AFR) AN T1: Engine Coolant Temp ANT2: Inlet Air Temp I am not running the air regulator or A.C.C Valve. I Have taken a 13mm pipe from the inter cooler in behind the throttle plate and plated up the A.C.C valve. Is my C.A.S correct? Also any advice would be niceÂ
  3. Hi I have just set my G4 Storm up for 1st time run. All the parameters have been set up how ever at the bottom of the Config page everything is off. How do i turn it on? Thanks
  4. Thanks how would i go about running the on board map, Instead of my M.A.F sensor? Yes i do still have the igniter
  5. Hi iv just gone a got a G4 Storm for my CA18Det Im running a stroker kit LC1 wide band Lamba F.P.R 1000cc High Inpen injectors Im going to be using the bosh sensor aswell I dont want to run the map sensor so im going to use the in built map sensor.  Is there anything else that im going to need and is the a base map i can load to start me off?
  6. Hi i have a ca18det witch has just been stroked to a ca20det, i also have a 3071r turbo upgeade, 3" exhaust, and uprated inlet and exhaust manifolds. I am looking for injectors around 1000cc. I just wanted to no the cost of the v5 upgrade also can i get a map for a ca20det? Also what else do i need to do so i can plug it into my laptop for tuning also i want to run a map sensor i have a green and white box the chip says D42I2WG 180199 My email is [email protected]
×
×
  • Create New...