Jump to content

stuart bell

Members
  • Posts

    4
  • Joined

  • Last visited

    Never

stuart bell's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Car now up and running , yay !! power supply and signal for crank sensor needed swaping round . Had to set timing offset to -170 degrees , does this seem acceptable ? Car going for rolling road set up soon , looking forward to the results after all the work put in .
  2.  Hi , yes that is correct . Both cam & crank sensor are hall sensors . Cam wheel has one cut out in it rather than actual teeth . Going to re check wiring to crank sensor the came supplied with the kit i bought as i've just found out i's from a different manufacturer to the cam sensor .  Stu Â
  3. I have fitted coil on plug ignition to my gt4 celica with 3sgte engine , now it won't fire . Using 1zz ignition coils and cherry hall crank & cam sensors . 12 tooth wheel on crank , 1 missing on cam . Problems i'm having are , engine won't fire and no spark while cranking , but it does fire when the key as released . In run time i'm seing trig 1signal all the time even when not cranking , trig 2 signal comes in when cranking , eccs syn no all the time (what is eccs ?) and finally , trig 1 error count = 2 . Ignition settings ar as follws.. Ignition mode = direct spark Spark edge = falling Dwell = ms ignition delay =80 us max advance 45 degrees  Trigger settings Trigger mode = multi tooth Trigger 1 priority = trig 1 Trigger 1 type = hall Trigger 1 pull up = on Trig 1 edge = rising Multi tooth position = crank Tooth count = 12 Trigger 2 type = hall Trigger 2 filtering = level 1 Trigger 2 pull up = on Trig edge = rising Sync mode = cam pulse 1 The next bit is a concern as i'm not sure if it's user error or what . When i go in to calibrate it shows the following . Trigger offset = 0 degrees Ref timing = 15 degrees Then set base timing. When i open 'set base timing ' and attempt to change the settings nothing happens , as in i can put in my trigger offset and ref timing but nothing changes . Does the engine need to be running before i can alter these ? I' pretty sure i have the trigger wheels set up correctly , but if someone could confirm the correct settings for these it would be appreciated .  Regards Stu
  4. Hi all, I'm looking for a base map to get my st205 enigined gt4 running 2.2 stroker kit with garret 3071 turbo and 800cc injectors. I believe it's not safe to run the motor in on these injectors with a base map for the 540cc standard type. Any help would be appreciated.
×
×
  • Create New...