hey guys i got a link g4 p&p plugged it in and setup all the sensors as the manual said. i used the map sensor option of a v7/8 option since it was the closest to the barometric sensor reading since the v3/4 option was way off to about 78kpa where the barometric read 101kpa . the car would not start but the car cranked over at a good speed. when going through the software and looking at the trigger status it said no trigger 1 signal ,trigger 2 signal, no eccs signal and the trigger 1 error count was 65. the trigger 1 arming voltage was 0.50v and trigger 2 was 0.48. the rpm limit data was 5000 and the map limit was 180 kpa.
Â
any ideas to how i rectify this error and get my car running haha.