Jump to content

charles hopkirk

Members
  • Posts

    18
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

charles hopkirk's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. So I cant get another disk for the bored that is installed already?
  2. Ok so I will need to change board and get a new cas disk for that board? If so what cas trigger disk would I need to get made how many slots etc?as I have some already?
  3. Ok cheers have sent you email with picture
  4. It's doesn't come up only 'insert other media' on the right hand side is availible. I've tryed it on chrome and explorer unless my systems are out of date.have you got email and I'll send that way?
  5. ok thank you.i do have a picture but i cant work out how to get it up on here. ive put photos up on here before but cant find where to add a attachment?
  6. Hi there I have a link g1 v5 that is set up for a 1ggte and I would like to run it on a rb.question is was the link set up for the factory toyota 1ggte trigger wheel or another as I'm planning on changing the trigger wheel in the cas but would like to identify what it was set up for?then I'll get the appropriate one made.
  7. what is the per hour charge? after the minimum charge?
  8. unfortunatly i dont have a tuning module.do you guys have one that i can hire and try?can i use osciliscope to check for communication between ecu and serial link and serial link to pc? Â
  9. i uninstalled the G1 pc link that i had then downloaded the link that you supplied tried it and no connection.went through power supplies and checked all grounds everything is there as it should be.the seial link isnt that old and in really good condition is there any way i can test the serial link and the connection to the micro?Â
  10. i downloaded the g1 PCLink off this site.is ther any others? it only has 8 com ports to chose from and hasnt made a difference.
  11. hi there. ive got a early generation plug and play gts link but cannot get the pc to connect to it have tried diffierent com ports checked ground and power distribution but still nothing.i would like to do some pre start up checks.this is the second one ive come across that i havent been able to connect to in  with the same pc.i have attached a file of a picture  inside the ecu.
  12. yes it is a wire in. ok are you still able to buy new looms for these ecu's? whats the email for sales?
  13. ok cool no worries.i have a customer that has also brought a gen2 link ecu that was set up for a 1jz-gte. is this able to be configured to running on a rb25det with out to much hassel?
  14. sweet cheers thank you is this ecu able to be up dated to the g4 software?
  15. sweet all good.have managed to get the ecu.is the seriallink still available?is all the information about this ecu available off this site?
×
×
  • Create New...