Sorenjensen
-
Posts
23 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by Sorenjensen
-
-
Is a plugin, i have
-
Thanks for the help.
The pins on the ecu , I was looking for
-
Hi.
I need an external map sensor on my Nissan skyline, it has a link 4g ECU, some that can tell me where to install the three wires.
Regardes Søren
-
Ok thanks for the reply
regards soren
-
Hi.
I have a link 4 g ecu in my nissan skyline r34 gtr, but in the ecu is only a 2.5 bar map sensor, with a maximum of 1.5 bar boost, how can i install another map sensoe, to get more boost on.
Regards Søren
-
I've figured it out.Â
-
Okay, Haw many measurements should i do, and howi write it into the pc
-
Hello again.
how do I calibrated my aem air / fuel wideband to link 4g. at my watch shows about 14.7 to 15.2 at idle and on the PC shows the 8.7 idle, I will run quick tune program. because it gets too much fuel, the car is nissan skyline r34 gtr.
Regards -
ok thanks.
-
Hello
I have set your air / fuel watch over my ecu box, red wire pin 49 black wire pin 50 white wire pin 29, and will then run quick tune, but it gets no signal, what have I forgotten to do, or I mounted the white wire wrong.
euc is link 4g plug in for nissan skyline r34 gtr.
Regards søren denmark. -
Hello. ok I will try when coming home from work.
Regards søren
Â
-
hello.
I adjusted it up and down the table, but when there is boost pressure is the air / fuel goes into the red zone, so that they may find out when they maper its.
Regardes Søren
-
hello.
I thank you very much for your help, it has been a great help , I will transfer the gasoline table tomorrow morning, and write how it goes.Â
Regards søren
-
Where can I find the main fuel table and adjust the table
-
Yes   a wideband air fuel meter to check Air Fuel Ratio's, I upload the file and try to start up Again.
-
yes it can start. but it gets to much gasoline, where can I adjust it.
it should read
regards søren
-
yes it can start without giving it too much gas, where can I adjust it.
Regards søren
-
hello.
I will try, so'll let you know if it works, but many thanks for your help.
Regards -
how long do you answer the question, is 11 hours ahead of you, so it's night here
hope you can help me, I need the car mapped.
Â
Regardes søren
-
fuel injectors is Rc racing (rc pl 4-1000)
Â
Regards søren
-
it is a plug in box, the original is removed, What is it I have to send you the program as I have read into the box.Â
Regards søren
-
Hallo.
I have come to load a program into my ecu that comes with the software I dovnloader to my PC, the program is nissan skyline gts-gtr, and has unfortunately not saved the old setup, so now the car will not start, it gets fuel but no spark at the spark plugs, what can I do other than make a factory setting.
The car is a nissan skyline r34 gtr with 1000ml fuel nozzles and stoket to 2.8
Regards søren denmark
Map sensor
in Link G4
Posted
Many thank for your help.