[MR2 Rev2 Loom for LinkPlius G3 ecu]

Link produce a plug-in ECU for the MR2 rev 2-3. I recommend using the pinout and pin function charts for this ECU to help you allocate the pins from the factory connector to the G3 Linkplus.

Here are the pinout and pin function charts:

r

So for example 'ISC close solenoid' would go to Aux Output 1, which is pin 5 on the MR2 connector and 'Aux 1 (Orange/Black)' on the G3 Linkplus.

Make your self a spreadsheet to help organise all the pin connections, then upload it here and someone can check it.

Scott

Thank you very much Scott thats  actually what i been looked for 

[MR2 Rev2 Loom for LinkPlius G3 ecu]

hi guys i need help with loom. i need make loom for Link g3 plus ecu for my mr2 rev2 but little bit scare to do something wrong and burn or damage my ecu . i got photo with both pinouts and some one edit that picture. add arrows  on correct pining  i will be so happy. Thank you  

[3SGTE]

You've been looking for 18 months?

If your ECU is able to be upgraded to the latest firmware, it comes with a base map for the ST185 from memory.

lool yeah been put ecu on shell used another one. time to put that one 

what else i need after update. do repining too ?

[3SGTE]

still looking for 

[HELP Base map for 3SGTE]

hi just bought used Link ecu would like to tune my MR2 Rev2 ot like gals st185  3sgte engine. but dont have base map. maybe got some one and would like share with me ?

[3SGTE]

Ecu is LinkPlius G3. firmware should be 1.9 Engine is 3SGTE Mr2 Rev2 or like its call ST185

[3SGTE]

HI guys just bought LinkPlius G3. and have problem cant find base map. 

If some one share map i`m be very happy 

[email protected]

Thank you