Rbmadhead

Thanks pal great info I’ll download software now cheers

Thanks that great help Is the v88 available as board only as can only find it in a metal case like this on website cheers

The serial number is pcb rev 1.1 Serial #15797 hoe this helps

Hi just purchased a vipec and these are the number evo 4-8 bb v1.2 is this a v series and what is the correct software to download thanks for any help

Hi got a vipec ecu and trying to figure out which model I have on the board is says evo 4-8 bb v1.2 many help appreciated

That has completely baffled me pal I’m not clued up on mapping

Hi is it poss to put pops and bangs on a switch so can be turned on and off cheers And can I be done without a clutch switch thanks

Changed plugs and now runs great many thanks for your help

I see many thanks for help

What is bap new to this cheers

Hi was wondering what should my map sensor readings show on idle and with engine turned off many thanks

I tried and car still runs rough think I’ll take plugs out and clean them up and try again

Ok I will try these settings and let you know thanks for help

The sensor is a aem And here is the tables And not sure if makes a big difference but max boost is 1.9 bar thanks for helping

Hi still looking for any info looked into map sensor cal table and it say in bottom two tables 100kpa and then 200kpa

I recently had a external map sensor fitted and a xs loom to do it how do I go into ecu and check the settings are correct as I have a misfire on high boost but runs ok and low just double checking please any chance of a beginners guide to check thanks for any help in advance

I've read u can fit a internal 7 bar map sensor is this poss and who would I get to do it any recommendations local to midlands thanks

Hi checked and the wireing from the old afm is 5v so can use that now how would I change over from internal to external cheers

Has anybody got a link to the expansion harness I would need to buy as sounds a lot easier to do cheers

Is there a guide to it as new to this pal and I read you can use 1 of the afm wires as they no longer used cheers

Thanks pal

Hi running a rb26 r32gtr and want to run external map sensor bought aem and was going to use the afm wireing is it easy to swap over from internal to external any help appreciated

Hi was wondering how to turn launch controll of its rb26 if that makes any difference thanks for looking

My ecu isn't a G4 storm it's a G4 only does this make any difference

Yes I did get email thanks can I not use my original knock sensors to controll knock on a rb26 or do I need a external knock controll sensor thanks