Gosman

Thank you very much!

Hi! Thank you so much for the picture, that's what i was looking for. I have this mapsensor and this connector cable, i don't have the wire scheme for that, could you make the same picture but with this mapsensor?

Hi, I'm about to connect both external Link MAP sensor 4Bar, and and Bosh IAT to the standard MAF connector on my EVO 4. This is how the MAF connector looks like, I have the stanard connector plug from map sensor so i got three different cables, which cable goes to which pin on the MAF connector? Also the IAT will come with two cables, which pin on the MAF connector?

Thanks you for a fast anser. The engine i runda in my evo 4 is an evo 8 engine, i will check you The link you provided and see if it helps. I will be running FIC 2150cc injectors so i guess i will be useing an dummy plugg for the resistorpack.

Hi, Two questions; I have a problem, when installing my Link G4 PNP Evo 4-8, my fan started on full speed, is there something i need to change regarding pin setup or similar?Should i run with a resistor plug if i run High Impedance Injectors?