ant.likko

Thank you for your answer. Will be correction applied for Cyl 1 and Cyl 4 from table Knock Ign Trim Cyl 1? Or only for Cyl 1? ----- Sorry, bad question. I should use same Knock Ign Trim Cyl table for pairs of cylinders in Cyl Allocation.

Scott, thank you! Now I have the following problem. Knock Level Cyl 1 and Knock Level Cyl 4 all the time the same. Knock Level Cyl 2 and Knock Level Cyl 3 all the time the same too. Screenshot in attachment. And knock trim only applies to Knock Ign Trim Cyl 1 and Knock Ign Trim Cyl 3. Where could I make a mistake? Vi-PEC's Digital Knock Amplifier settings: Frequency switch is C, Gain switch is 2. Is it correct settings? Thank you for all your time and effort.

PCB Rev 1.2 Evo 9 BB V1.1

Scott, can I use expansion cable in V44 top-board? All inputs will work? Page 11 in http://www.vi-pec.com/techdata/vipec-evo9-plugin.pdf I can't find distinction V44 and V88 in Evo 9 plugin manual Thanks!

Thank you very much! It's rally car. I'll use DI4 (A/C Request) for VX ECU Digital Input.

Hello, I have Evo 9 with Vipec Evo 9 V44 PnP and Vipec Knock Amplifier Kit. My questions: 1. Which wire (VX ECU Digital Input or ECU Analogue Channel or Gauge Input) from Knock Amplifier I should to connect to Vipec ECU? 2. Which input I should use in Vipec ECU for a knock signal from Knock Amplifier? In manual http://www.vi-pec.com/techdata/vipec-evo9-plugin.pdf speaks of Knock 1 (91 pin). 3. Should I use value C for Frequency Configuration for standard Evo 9 knock sensor? Thanks in advance.