Christopher Kafkalias

thank you Adam,done the changes and it seems to working ok now. other thing after upgrade is that when i store to ECU it says ''store failed'' but it actually stores-saves the changes made. any way i can fix this?

hello guys, i have a PnP G4+ on my Toyota MR2 with ethrottle. i have just upgraded the firmware from 5.1.0 to 5.6.7 and when i start the engine it doesnt idle steady,it fluctuates and i can see the TPmain going up and down from 3% - 8% . i did a data logging but i cant figure out whats going on. BTW, i downgraded back to 5.1.0 to check and engine idles normal. any suggestions?? before firmware upgrade.pclr firmware upgrade.pclr Log 2020-05-19 2;27;39 pm.llg

LINK G4+ plug in E throttle setup I have an issue with calibration of the throttle Ive entered all the PID values and voltages suggested in the help file , when i try to calibrate it, the throttle plate opens full and closes but i get error”tps movement zero” I checked in run time values the analog volt inputs that are set to TP main and TP sub and when i move manually the plate i get volt readings as normal Any suggestions? Mazda RX8 throttle and pedal