victory

can you support me with the wiring diagram or if you have some thing ready i will order it. what i am thinking the i will do it as a piggyback with the stock wiring.

Hi, i am going swap a 5.7 doge RT engine into a Jeep Wrangler and i want to run it with LINK ECU and i need your help and advise on this.

Hi, i am having an issue of getting my motec c127 with gear position. The engine is a supercharged 6.2 LSA swapped into a Nissan Patrol wired to an Exterm ecu , with 6 speed GM transmission 6l90 wired to a PCS TCU i am trying to get the Motec C127 to read the gear position P,R,N,D and M 1,2,3,4,5,6 so what type of sensor should i use to let my ECU detect the positions, also i need to get the speed from my trans. to the Link ECU and then to the dash. i have a speed source from my TCU. so should i wire it to a digital in the ECU.

Thanks for your support, i am having 6pin pedal for camaro, the throttle working fine the padel also reading but still it is not wroking ethrottle test1.pclr Log 2019-07-7 8;18;13 pm.llg

Dose any one has an information on LS GM paddle wiring on thunder

Hi, Looking for a trigger setup for chevy LQ9 engine, this engine is working only with one trigger on crank.

Thanks, I got it from the folder.

Looking for a base map for EVO 8