jonas

No, I'm from Sweden. Did you find a solution?

Have tried 4 and 10 'High Scale' there was not any difference. It could be something wrong with the cable from the ECU to aim? We have made a new cable, others were broken at the connector to the ECU. It is something specielt with original cable? has attach a PCLog file Jonas test1.llg

Hi Scott. I'm not sure it shows the values may not be with them in the log. This is the base map, log and AIM setup file Jonas 201608.pcl teest.llg can seat.cfz

Hi Scott, Have a look at the settings I do not see anything wrong. It still shows negative values of oil and fuel pressure, but when you turn on the ignition key so normally the value until you start the engine. Any other suggestions on what can be wrong? Is there any settings you have to change when you go from the RS232 serial protoco to CANbus?? Jonas

Hi, Has to change canbus now shows the negative values of oil and fuel pressure. What could be wrong?

Thanks for the help.

Hi, When I updated the firmware wear so I got up an error message that it was canceled. now it will not update .How should I do to make it work?

AIM MXL starada coupled to a Link G4 extreme. does not show oil and fuel pressure that is associated with RS232 serial protocol, it only shows dashes on the instrument, what could be wrong? The values demonstrate the PcLink as they should.

If there are problems with the new firmware. it is possible to reverse to an older firmware?

Firmware update from 4.7.0 to 4.10.2, it will be any problem to do that? Is there something you should consider before you do it?