Jump to content

noodle

Members
  • Posts

    4
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

noodle's Achievements

  1. So - revisiting with mechanic (James). We have it running intermittently, varying from start to start. Finding that the prime (Acc/fuel) and leaving it on for a little while and then crank/start (IGN) will work. But once again. Only works a couple of times... What we have done is change the Transmit rate from 20Hz to 10Hz as stated on another thread (http://forums.linkecu.com/index.php?/topic/5268-can-bus-wiring/ ) Photos for reference.
  2. So when the engine is off - it displays this (showing numbers) when the engine is running it displays nothing... And....... Now it's working. Lol. Might keep playing.
  3. Thanks Scott. I'll have a look tonight. Hopefully it resolves it... A little bummed about it. haha.
  4. Hi All, After 8 months of my STi being off the road - finally got it back running a whole lot of new gear (Thanks to Matt Ashley for the Tune). Including the Link G4+. Prior to this I was running another ECU (Aut****) that connected the RS232+, RS232- and negative to an aux jack which went into the ECU. Now that I have the Link G4+ it has a separate CAN/RS232 pin out which you need an adapter for (purchased both CAN/RS232 ECU Adapter, Spare CAN plug and connected both). I have connected/wired the CAN H and CAN L to the AIM CAN + (to H) and CAN - (to L) as per instructions. Set the protocol up (as per AIM instructions) on Software/Link ECU (CAN SETUP) and Race Studio 2. Now - everything on Race Studio seems to be reading correctly after setting it up as a new 'profile'. However, once car is running - data is not being transferred (RPM/Gear/etc). How would I go about this? I'm going to attempt again tonight and re-check solder/wires etc. Regards, Nick.
×
×
  • Create New...