Roshitha

Hi, I’m working on a JDM evo9 MR with Link G4x pnp 7bar ecu.when i connect the ecu it started fine at 1st shot but having very wired idling, it goes iup and up until it cuts the fuel. It hunts all the way to 2000rpm. I’ve tried playing with idle settings but t it doesn’t look responsive to the settings. Do i need to swap wires or connections from the aux output settings. Because for the stock ecu this car runs very well.

Hi, is there any possibility to use ecu master CAN lambda device to talk with Link G4+ ecus via CAN. I tried it works with the analog input. But need to work it with CAN, any help would be appreciated. Thank you.

Hi,thank you for the quick replies. But will i be qble to run sequential ignition with this trigger pattern

Hi,I'm working on a project Nissan micra K11 CG10DE engine and i'm trying to install Link G4+ Atom ECU. but the problem is My Micra triger patern does not show in the software.also i searched everywhere to download a user manual and a wiring diagram for this G4+ Atom but i did not found.if someone can help me on this it would be much appreciated. thank you.