Ignacio

I asked in Race-Technology too and I'm waiting the answer. While, I ask here if anyone know something. Thank you Adamw. I used various cables and I have the same problem.

Finally I could go to the workshop and try it. The Dash is not Dash2Pro, is Dash2. Although the menu is similar, I have two problems: 1. When I connect the PC directly to the dash by a serial cable, if I want to read or send the configuration, after a few seconds, the software tell me that It's not possible to continue reading (sending) 2. When I want to change the data source for speed signal, I have this: And when I go to CAN configuration, I have this: However, although is this list doesn't appear any channel, on the dash' screen we see temperatures and pressures (that are connected to the ECU too, not to the Dash), so I'm a little confuse. It's the first time that I configure a system like that so sorry so much if there are many obvious solutions that I've not seen before. Thank you very much for everything.

I'm going to try it. Thank you very much to everyone!!

Hi everyone! I have just started to work with Link G4 ECU and Dash2 from Race yechnology and I have a problem with speed definition. I only have a wheel speed sensor that I installed in RR wheel. With it, in Chassis and Body menu, I fill the speed source as the image bellow shows. At this point is everything ok? If the speed is well defined, the problem is when I send the information to the dash. The speed is not read. What could be the reason? Thank you very much for your help.