Jump to content

Lazy6

Members
  • Posts

    2
  • Joined

  • Last visited

Lazy6's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Having a solenoid control the pressure signal to the BOV could be an idea. It would be tricky to tune because the pressure line to the BOV carries both negative and positive pressure, and both are needed for operation of the BOV. It would need to limit the amount of negative pressure reaching the BOV under part throttle operation only. Is that something that could be done? Or maybe I just need to find a stronger BOV spring. As I said, I'm already using the biggest one Tial sell, but maybe I can get a stronger spring from somewhere else.
  2. Hi team, I have an Evo 6 with a Link G4+ installed and it has been tuned by Possum Bourne Motorsport here in New Zealand. The car has a few bolt-ons but still runs standard internals and turbo. It's been tuned well and runs really nicely. However I do have a disappointing issue with Anti-lag when used in conjunction with a blow off valve. The anti-lag is configured around using the Idle Control Valve to bypass the throttle body and allow air into the engine which is ignited with some timing changes to get the turbo to create boost while off throttle. But because the throttle body is closed there is still a pressure differential between the manifold and the charged cold side and the boost all flows out of the BOV. The above scenario is actually fine. It's better the boost flows out the BOV rather than backwards out of the turbo and creating compressor surge. However, the problem I have is part throttle usage. During engine braking into a corner, the anti-lag fires, the BOV opens and the turbo spins. But as I apply the throttle, the BOV remains open or flutters and it causes the car to jerk about undesirably. If I go to wide open throttle the BOV closes. But at any part throttle usage I have the issue as described above, which stops me from rolling-into the throttle as I round corners. I'm running a Tial 50m BOV with the stiffest spring they provide. This is a street car used for occasional track days so do not want to disconnect the BOV and blank the hole. Help here would be appreciated in how to deal with this issue!
×
×
  • Create New...