My first (and maybe stupid) question on this forum:
I have a engine strapped on the engine dyno from which i struggle to get a starting rpm during cranking.
The concerning setup has a custom trigger setup (60-2 / reluctive / air gap 0.9mm) and is controlled by a Link xtreme ecu (program attached: 3s-gte).
Already tried a few options:
-Triggerscope is getting signal(also attached: Trigger_1)
-Polarity swap of the reluctor sensor.
-Setting arming treshold at different values (included it's minimum value of 0.2)
-Setting different values for filtering
Normally i would swap over to a hall sensor but since the wire loom is already twisted and tucked in raychem this isn't one of my options...
Can anyone tell me if i'm missing something?