Remski
-
Posts
5 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by Remski
-
-
Hi.
I've changed the following and modifying the fuel map now works.
Min Effective Pulse Width= 0.125
Master Fuel=10
Master Fuel Trim=0
Injector Timing = 400
Thanks for your help gents.
Remski
-
Thanks.
Will try that and post back.
Remski
-
I've tried few Master Fuel setting.. went down to 4 ms as well.
Had it at pretty much all even numbers between 4 and 24...
With 24ms the mixture was too rich and the car would stall..
Now.. even with settings 8 and 4 modifying Fuel Main did noting.
My afr is now at 11.2-11.6 at idle and I cant get it to go lower than that.
Am I doing something wrong ?
AFR is 11.2 i go to Fuel Main, right click on table, offset by %, -10 % , nothing happens, -10% again nothing happens all the way down to 0 in the whole table..
Also tried the quick tune with wideband connected and that did not do anything either..
Please advise..
Thanks
Remski
-
Hi.
I've just put this map together.. copied the parameters off a base subaru map.
Car starts and idles but I cant seem to be able to change the AFR.
Any modifications on the fuel map do nothing. I can go as low as 0 and afr stay the same.
Injectors are ID 1000.
Once I shut off the car and want to start with low values in the map the car doesnt start .. i have to re-copy the table.
Thanks
Remski
Subaru Electronic Throttle Pinout
in G4+
Posted
Here is the pin-out I used.
Throttle body is off 2005 sti.. (note.. I had to switch pins aux9 and aux10 around since the plate was closing not opening.)
And here is the accelerator pedal.
Same thing .. off 2005 sti.
Orange denotes shielded cable that I used.