Jump to content

Alex Hewson

Members
  • Posts

    4
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Alex Hewson's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Hi Adam Cheers for the reply, i found the issue and it was nothing to do with settings. I tried another 3.5MM lead but this one was a 3 ring instead of a 2. Turns out even if you push the 2 ring 3.5MM lead into the port so it clicks it wont work, i had to pull it out slightly. Something so simple.
  2. Afternoon all sorry for the daft question but im having abit of issue setting the knock audio up correctly. I currently have the link knock block with both sensors mounted in the factory spot on the block, along with a 3.5MM jack lead to the laptop When following the instructions to set up the knock audio i'm getting back ground noise through my microphone on the laptop. i have tried another laptop and the same issue occurs. I have had a play around with some of the settings on the laptop but none stop the issue. The knock audio will still pick up KHZ when the knock block is turned off with the engine running. is there a specific setting you have to change on the your laptop? Im running Windows 10 as well.
  3. Cheers for the replies, the ECu is still stuck in the boot mode and unable to connect. So far i have tried; Disconnected the battery over night for 12 hours Uninstalled the PC link software and deleted all files and re downloaded Updated the drivers and tried on another laptop Connected manually via COM3 and COM4 ports. Tried to update firmware before going online, error message "initMonitor" failed, "Monitor:BSL no aknowledge received", "Com receive: timeout or lost of data" Attempted to run firmware update again and an error message NO_COMPORT_HANDLE Attempted to go online and an error message of "could not connect to ECU" ( the ECU has power as there is 12V across the ECCS relay) Im out of ideas to what else to try at the moment. Is there a way to manually reset the ECU without going online as i do not the have the ability to get online to restore to factory settings?
  4. Afternoon I have a slight issue of that i went to do a firmware update due to having issues with the Link CAN lambda module not being found. I started the firmware update and left it going and as i got out the car the force of habit i turned the ignition off. I realised what i did but now the ecu is stuck in boot mode in which i can not connect to the ecu or do a firmware update as it comes up with NO_COMPORT_ HANDLE. is there a way to reset the ecu? Thanks Alex
×
×
  • Create New...